Manual
1- Tie a knot and place the knot on the small stick
on the side of the loom. Cast on like this: bring the
yarn towards the middle, and wrap the yarn around
the first peg from behind.
2- Continue like this all the way around. Finish at the
small stick on the side of the loom which is the start
of the round. Wrap the yarn around the stick.
5- Pull the bottom thread over the top thread by
using the included knitting loom pick
6- and further over the peg. Now, you have knitted 1
stitch
7- Continue around with 1 round of wrapping the
yarn around the pegs, and 1 round of pulling the
TIP: Knit the last stitch of the round first, so the yarn
is secured. Knit the rest of the round.
yarn over (knitting). If you like, change color as you
go.
8- When a few rounds have been knitted, untie the
knot and bring the yarn tail towards the middle.
Change color: Place the “old” yarn color through the
work. Tie a knot with the new color and place it on
the stick on the side of the loom. Continue around
as you did previously.
Finishing off: Cut the yarn leaving a tail of 10.7
inches (50 cm). Place the end on a thick needle and
lift the stitches off individually, so the stitches are
placed on the yarn.
Tighten the yarn so the hole is closed. Weave in all
ends.
The edge is rolled up or folded, and sewn on the
wrong side.
Happy knitting☺
Love Hobbii
